Friday, February 19, 2016

OSCaR report on cancer rates near Bullseye Glass


The OR state cancer registry (OSCaR) released a report today examining the rates of lung and bladder cancer in census tracts near the Bullseye Glass factory in southeast Portland (OR). This district of the city is the location of elevated exposures to cadmium and arsenic measured by the Department of Environmental Quality (DEQ), and understanding whether those exposures pose a threat to human health has been a pressing issue.

The OSCaR report is based on comparing observed rates of cancer in census tracts near the site of the metal emissions with observed rates of cancer in the county overall. Specifically, the study calculates Standardized Incidence Ratios (SIRs) for both lung and bladder cancer. Those ratios divide the observed number of cancer cases in sites of exposure by the number of cases expected based on the number of people living in those sites (again using the county as a whole to best estimate that baseline rate). SIRs greater than one indicate an increased rate of cancer in the study area, while an SIR less than one suggests cancer rates in a study area are actually below baseline rates.

Here are the SIRs for the census tracts near the Bullseye plant:

As you can see, the ratios are close to one for both cancers, whether including just the census tract that includes the plant, or adding the adjacent census tracts to the east. That is good news!

You may notice that the confidence intervals for the study are large. These are 95% confidence intervals; they essentially tell you that, for example, the actual SIR for bladder cancer in tract 1000 has a 95% chance of falling between 0.3 and 3.1 given the number of cases measured. That number of cases is what makes the confidence intervals large; in this example it is based on four actual cases reported among residents over the five-year study. You can see why the CIs would be wide; having just one more (or one fewer) case of bladder cancer in that tract would change the rate by 25%. Since the number of cancers reported is small, the confidence intervals are broad. I should point out that this is a good problem to have - the cancer rate is hard to estimate because there are not many cases! From a statistical point of view, if the confidence interval on an SIR includes the value 1.0, there is no statistical evidence that the rate of cancer is different in the study area. That is clearly the case in these data. Even better, the actual estimates of the SIR are all close to one; this is very reassuring.

There are limitations to this analysis, of course. First off, given the low number of cases, it is just not sensitive enough to pick up very small changes in the cancer rate. The differences between the estimates above and exactly one are small compared to the confidence intervals, yes, but realistically the study does not have the statistical power to pick up a change in rate less than about two-fold (for bladder cancer) or 1.5-fold (for lung cancer) in the study area. There just aren't enough people living there (and not enough reported cases) to be more precise. In addition, the conclusions are limited to the two cancers studied, though those are the cancers known to have the strongest links to arsenic and cadmium exposure.

I'm personally very heartened by these results, for a few reasons. First off, because the data were collected for cases that pre-date the release of the DEQ emissions testing data, we don't have to try to adjust for reporting biases. Second, the exposure thresholds for cancer tend to be among the lowest exposure thresholds in the health-effects literature; you would expect to see cancer effects at lower exposures than for acute diseases caused by heavy metal exposures. I don't want to give you the impression that we're measuring 1 in 10,000 risks well in this study; the total population in the study area was 13,725 - so the result of an increase of 1 in 10,000 would be just over one additional case for a given cancer. But I'm encouraged that the predictions that come from examining the DEQ emissions levels hang together nicely with this result from cancer rates; any additional risk for human health effects looks to be small (or less) for cancer; hopefully that conclusion holds up for other types of disease.

Finally, I want to congratulate OSCaR for the study; I imagine that running a cancer registry is rather low-profile and out of the public eye until you really need that registry to answer a question like "Should we be concerned about cancer from these arsenic and cadmium emissions?" Then it's really nice to know that the data have already been collected, and within a couple of weeks of the first media reports we have a direct, evidence-based answer to that question. Thanks to everyone at OSCaR!




5 comments:

  1. Another good post!

    One possible flaw in the OSCaR analysis is that it compares cancer cases in the Bullseye area to the county as a whole. When I attended the community meeting at Tubman last night, I realized that that there are a lot of areas suffering from really bad air quality problems in Portland, which obviously dominates Multnomah County. So it may be that we are comparing the Bullseye area with a worse-than-ideal comparison group, so even a moderate here effect might not be visible. That is to say, without Bullseye, it seems possible that we'd expect this area as being better than the county as a whole.

    I guess what I'm saying is that I agree the data suggests we are not seeing a huge effect, but the datasets are so small (thankfully), and there are enough confounding factors that I don't feel fully confident in the conclusions.

    ReplyDelete
    Replies
    1. You're right that if our air regionally isn't great, that a comparison with the whole county would not pick that up. That's kind of the point, though; this analysis is supposed to see if proximity to Bullseye is worse than the region as a whole. I've seen suggestions that EPA keeps track of regional differences, but I haven't dug up the data...gotta sleep sometime!

      Glad you liked the post!

      Delete
  2. Personally, I think BE has a publicity nightmare here. Regardless of the findings, there are those that are not educated enough to understand the findings or who think there is some consistency theory going on. Sad but true. I think that BE is going to have to take the higher ground on this one and purchase the much more expensive collection baffles. I was looking for the specific name, I know someone said what they were, but anyway. Unfortunately, people are nuts right now. Please don't get me wrong. I think they should be concerned just not over zealous.

    ReplyDelete
    Replies
    1. I can see the benefit of updating the emission filtration at the two glass plants pinpointed by the Forest Service analysis; they seem to be bumping up cadmium (and maybe arsenic) regionally, so fixing those point sources seems like an effective solution. But there is lots more to work on, which is why the idea of a Regional Air Quality Board sounds good to me. Maybe they can get diesel emissions updated!

      Delete
  3. Birkan Engineering is one of the best companies in the field of glass and thinners products since last 5 years. It also provides Heat Soaked Glass, Solar Glass in Ghaziabad.

    http://www.birkanengg.com/products.php

    ReplyDelete